0.5ml Clear Plastic Microcentrifuge Tube Conical Micro Centrifuge Tube
Plastic Microcentrifuge Tubes
Material：PP
Working Temperature：-20℃—121℃
Centrifugal Force：20000RCF
Description
I. APPLICATIONS
1. Cell centrifugation
2. Molecular biology
3. Sample storage
4. Centrifugation of precipitates
II. FEATURES
1. Materials: Strong, medical grade polypropylene, autoclavable
2. Chemically resistant to alcohols and mild organic solvents
3. Transparent wall permits easy viewing of tube contents
4. Working temperature: stable from 20ºC to 121ºC (Autoclavable)
5. Tested to withstand centrifugation of 20 ,000 RCF in a fully supported rotor
6. Certified RNase & DNase Free
III. TUBE DESIGN
1. Conical bottom design fits most standard floor model and table top centrifuges
2. Molded graduations in 0.5ml increments
3. Clearly visible with either clear or turbid samples
4. Available in 4 colors: clear, red, yellow, and blue
IV.CAP DESIGN
1. Attached cap
V. PACKAGING
1. Bulk packaged, 500 tubes/pack and 10 pack s/case
| Cat # | Volume | Color | Sterile | Unit |
| 80-0500 |
0.5ml |
Clear | No |
Bulk packaged, 500 tubes/ pack and 10 pack s/case |
FAQ:
1. What are the main factors that influence the maximum centrifugal acceleration force?
Use of organic solutions, temperature below 0°C, centrifuging without centrifuge adapter, etc. Conduct a trial run to determine proper conditions before any critical use begins.
The RCF (relative centrifugal force) or G ratings for our disposable centrifuge tubes have been established at room temperature using tubes filled to nominal capacity with water and centrifuging for 30 minutes. recommended carriers, adapters, and cushions that fully support the tubes. If an angle head rotor is used or proper support is not provided, G values will be lower.
Do not confuse speed or revolutions per minute (RPM) with relative centrifugal force (RCF). Instructions for centrifuging a sample at a given RPM and time are incomplete unless the rotor or radius is specified. Protocols should always state the time and RCF value for centrifuging a sample.
2. What are autoclaving guidelines of plastics?
To ensure successful steam sterilization of your plastic labware please adhere to the following guidelines: PLEASE NOTE THAT NOT ALL PRODUCTS ARE AUTOCLAVABLE. Autoclave plastic consumables at 121°C and 15psi/1 atm for 15 minutes. Do not use a dry cycle, as this may cause deformation or weakening of the plastic. Allow temperature within the autoclave to return to 80°C or below before removing products.
Hot Tags: 0.5ml clear plastic microcentrifuge tube conical micro centrifuge tube manufacturers, suppliers, factory, price
Send Inquiry
You Might Also Like
