Know About Centrifuge Tubes
Leave a message
In many laboratories, there is a glass or plastic vessel composed of a hemispherical bottom and a cylinder, which is used to place radioactive or highly corrosive samples. It is called a centrifuge tube.

Methods of using centrifuge tubes:
1. Because the graduated centrifuge tube is a measuring gauge, it must be cleaned and dried before use.
2. When reading, be sure to observe the meniscus correctly, otherwise a certain error will be introduced.
3. When using, the number of centrifuge tubes shall be determined according to the model of the centrifuge. If a centrifuge with two casings is used for single test, the other centrifuge tube must be filled with the same volume of liquid to maintain balance.
4. The centrifuge tube and centrifuge sleeve shall be matched. The pipe should not be too long, otherwise it is easy to break when it rotates. However, it is not easy to be too short. Too short pipes are unstable when rotating in the air and are easy to cause breakage. If the sleeve is too thick, it will not enter, and if it is too thin, it will not rotate stably. The round mouth should be greater than the inner diameter of the sleeve.
5. After the centrifuge tube is sleeved into the casing of the centrifuge for layered separation, it should be stopped naturally when it stops rotating, and it must not be forced to stop by external force.
Precautions for centrifuge tubes:
When using a centrifuge tube, we should not use one tube for many times. We should pay attention to sample volatilization and leakage of some radioactive or corrosive samples; In the process of storage, it is necessary to seal well; Prevent the centrifugal tube from deformation.
Function of centrifuge tube caps:
Plastic centrifuge tubes are equipped with pipe caps, which must be tightly covered to prevent liquid leakage.
1. It is used for radioactive or highly corrosive samples to prevent leakage of samples.
2. Prevent sample volatilization.
3. Support centrifugal tube to prevent deformation of centrifugal tube.
Biologix Centrifuge Tubes

Features
● Tubes: made of strong, highly transparent medical grade polypropylene
● Flat-top caps: made of medical grade polyethylene
● Plug-seal screw on caps: made of medical grade polypropylene
● 15ml and 50ml conical tubes available;
● Large white writing area for easy marking
● Double threaded design reduces cross-threading; caps are easily opened
and closed
● Flat-top caps can be written on
● Gamma radiation sterilized, non-pyrogenic, RNase&DNase free
● Available in racked package (sterile) or bulk package (sterile & non-sterile)

Specifications
● Working temperature: stable from -20°C to 121°C (except flat-top cap)
● 15ml and 50ml tubes can withstand centrifugation of 8,400 and 9,400 G
respectively
● Sealing test: complies with the International Air Transport Association
(IATA) Safety Standards







